Basic Life Support Certification





 

Comments

Post a Comment

Popular posts from this blog

RISC-V ALU: Design, Implementation, and Testing

Image
 Abstract This documentation presents the design and testing of an Arithmetic Logic Unit (ALU) model for a RISC-V architecture. The ALU is capable of performing various arithmetic and logical operations while also providing flags such as Carry, Overflow, Zero, and Negative. Introduction The ALU is a fundamental component of any processor, responsible for executing arithmetic and logical operations on data. In this documentation, we focus on an ALU designed for a RISC-V architecture, which is a popular instruction set architecture used in many modern processors. The ALU model presented here is implemented in Verilog and includes support for flags to provide information about the result of operations. ALU Model  Logic Diagram  Flags and Operations The ALU supports the following operations: Operation Description Addition Adds two numbers together. Subtraction Subtracts one number from another. Bitwise AND Performs a bitwise AND operation. Bitwise OR Performs a bitwise OR ope...
Read more

Marshel Volunteering Activity

Image
  ·          Volunteered to clean and spread awareness about government school.                                                           February 2023 v   The activity was overseen by Marshel group in Hosakote Taluk. v   A survey was conducted to understand number of people aware of free public schooling and woman’s hygiene. v   A seminal on higher studies was also conducted for the middle school children.
Read more

GSM Based Remote Load Switching

Image
Abstract Today the energy meter is placed in the domestic or commercial sites and collects the data of the energy consumed and displays it on either a number dial or digital display. At the end of every billing cycle the person from the service provider has to visit the place where the meter is placed to get the reading and to note it down for further bill generation. The present system of energy charge is fallible and also long. So the purpose of this project is to develop an energy meter which is used to measure the consumer’s power consumption in kWh but also enable and support real consumption and, so meter reader does not need to visit each customer for the consumed data collection and to distributed the bill slip. The energy consumption is calculated using the measurement of voltage and current. It also continuously reads the energy meter readings and automatically sends some updates like low-balance alert, zero-balance alert, recharge alert when necessary, to the registered numb...
Read more